Applications include: Heat Exchangers, condensers, pumps, compressors, boilers. Available single and double jacketed.
|
|
Single jacketed with non-asbestos or graphite and no top washer. Protects both edges of filler material. For relatively narrow applications. |
|
|
|
Double jacketed with non-asbestos or heat resistant filler and top washer. Provides maximum filler protection. Most popular style for heat exchangers. |
|
|
|
Double jacketed with non-asbestos or graphite filler and top washer. Provides maximum filler protection. Most popular style for heat exchangers. |
|
|
|
French type - one piece metal jacket with filler. For narrow applications where positive, metal gasket face is required across full width. |
|
|
|
French type - two piece metal gasket with filler. For irregular or wide shapes not needing filler material protection or extra flange support at outer edge. |
|
|
|
French type - modified three piece metal jacket and non-asbestos or heat resistant filler. |
|
|
|
Inverted French type - one piece metal jacket and non-asbestos or graphite filler fully enclosed in single metal shell overlapped on one face. For narrow width application. |
|
|
|
Overlapping metal jacket. Non-asbestos or heat resistant filler fully enclosed in single metal shell overlapped on one face. For narrow width application. |
|
|
|
Concentric grooved profile gasket. Used where conditions require a profile type gasket and complete flange protection. For higher pressures. |
|
|
|
Double jacketed profile gasket. Used where conditions require a profile type gasket and complete flange protection. The smooth surface prevents scoring of the flange. |
|
|
|
Single jacketed profile gasket. Allows flange protection on one face. Jacket material may be different than filler material. |
|
|
|
Serrated metal with machined concentric ribs. Used where wide, all metal gaskets with reduced contact areas are required. |
|
|
|
Plain single sheet corrugated gasket for low pressure seals on smooth flanges with low bolt pressures. Low cost, light weight & more resilient than flat solid gaskets. |
|
|
|
Non-asbestos or graphite filler cemented on grooves of Style 900. Allows positive seal on rough or uneven flange surfaces. |
|
|
|
Double jacketed corrugated with non-asbestos or heat resistant filler. Corrugated jacket results in added resilience. |
|
|
|
Double jacketed corrugated with Style 900 filler. The metal corrugated filler offers a greater resistance to temperature change problems. |
|
|
|
Solid gasket-round cross section. Formed from round cross-section wire. Normally installed in narrow machined flanges used in low pressure and low bolt load application. |
|
|
|
RTJ gasket-oval shape-ASME B16.20. |
|
|
|
RTJ gasket-octagonal shape- ASME B16.20. |
|
|
|
RTJ transition gasket oval or octagonal ring type joint-solid metal. |
|
|
|
Lens gasket-solid metal-machined-a line contact seal for high-pressure piping systems. |
|
|
|
Delta-solid metal-machined-gasket that inserts into triangular groove . A pressure vessel or valve bonnet gasket used in pressure range of 5,000 psi and higher. |
|
|
|
Solid metal for smooth flange face and high bolt load. Great strength, good heat conductivity and resistance to temperature, corrosion and pressure. Many sizes & shapes -all metals and thicknesses. |
